T6339
• Please keep this instruction sheet for future
reference, as it contains important information.
• Requires four “AA” (LR6) alkaline batteries for
operation (not included).
• Tool required for battery installation: Phillips
screwdriver (not included).
Overhead Gym
Tummy Ti
On-the-Go Fun
1
Assembled Parts
Alligator Mirror
Hippo Toy
Hub
3 Tubes
Elephant Toy
Koala Bear Toy
Mobile
3 Linking Toys
Mat
3
Battery Installation
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
1,5V x 4
“AA” (LR6)
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• Locate the battery compartment door on the
mobile hub.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert four “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
Care
for longer battery life.
• Replace the battery compartment door and
tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• If this toy begins to operate erratically, you may
need to reset the electronics. Slide the power/
volume switch off and then back on.
• When motion/sound/lights from this toy
become faint or stop, it’s time for an adult to
change the batteries.
Hint: To remove the tubes from the hub,
simply press the buttons on the hub near each
tube socket.
Mat and Elephant Toy
• Wash in cold water on the gentle cycle. Do not
use bleach. Tumble dry low.
Tubes, Hub, Mobile and Toys
• Wipe the surface with a clean cloth dampened
with a mild soap and water solution. Do not
use bleach.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
• Do not immerse hub.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
T6339a-0920
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA
4
Setup
Mobile
Hub
Tube
3
• Fit the clip on the mobile onto the loop on
the hub.
1
• Insert and "snap" the tubes into the hub.
Tube
Mat
4
2
• Hang the toys from loops on the arches or
the mat.
• Lay the mat on a flat surface with the decorated
side up.
• Insert the end of each tube through the largest
loops on the outside edge of the mat.
5
Motorized Mobile with
Music & Lights!
On-the-Go Fun!
Song Select
Button
• Remove the mobile from the hub.
• Clip the mobile to a stroller for on-the-go
entertainment.
Power/Volume
Switch
Mode
Switch
• Slide the power/volume switch on the hub to
ON with low volume , or ON with high
volume
.
• Slide the mode switch to Music Only,
Music and Lights or Music and Motion.
• Press the song select button to play a song.
Press again to change the song. Music plays
for up to 20 minutes with each press!
• When you are finished playing with this toy,
slide the power/volume switch OFF
.
6
|